Cabletron Systems 2E43-27R Switch User Manual


 
Chapter 5: Local Management
5-46 2E42-27/2E42-27R/2E43-27/2E43-27R User’s Guide
NVRAM Installed (Read-only)
Indicates the amount of NVRAM installed in the 2E4X-27 and how much
of it is currently available.
Current Switch Utilization (Read-only)
Shows how much (percentage of processor capacity) of the 2E4X-27 is
currently being used.
Peak Switch Utilization (Read-only)
Shows the peak percentage of maximum switching capacity, since last
reset.
Reset Peak Switch Utilization (Toggle)
Allows the user to reset the Peak Switch Utilization field. The switch may
be set to either YES or NO as described in Section 5.13.1. YES resets the
Peak Switch Utilization field to the current system traffic.
5.13.1 Setting the Reset Peak Switch Utilization
To set the Reset Peak Switch Utilization field to YES or NO, proceed as
follows:
1. Use the arrow keys to highlight the Peak Switch Utilization field.
2. Press the SPACE bar to select YES or NO.
3. Use the arrows keys to highlight the SAVE command at the bottom of
the screen.
4. Press ENTER. The message “SAVED OK” displays.
5.14 HIGH SPEED INTERFACE CONFIGURATION MENU
SCREEN
The High Speed Interface Configuration Menu screen, Figure 5-21,
applies to the Fast Ethernet Interface Modules and the High Speed
Interface Module.
NOTE
This High Speed Interface Configuration Menu screen does not
display unless an optional interface module is installed: one or
two Fast Ethernet Interface Modules, or High Speed Interface
Module (HSIM).