Filter
Top Products
Port Level Security Configuration Screen
2E43-51/2E43-51R User’s Guide 5-65
7. Use the arrow keys to highlight the SendTrap field.
8. To change the SendTrap setting to NoTrap, press the SPACE bar to
toggle the setting.
9. To change the security on more than one connector, repeat steps 1
through 8 for each connector. Then proceed to step 10 to save all
settings at once.
10. Use the arrow keys to highlight the SAVE command.
11. Press ENTER. The message “SAVED OK” displays and all ports of
the connector are set to the selected operating mode.
5.20 PORT LEVEL SECURITY CONFIGURATION
SCREEN
The Port Level Security Configuration screen, Figure 5-27, functions
similarly to the Repeater Level Security Configuration screen, except that
it is used to set the security of each port of a connector.
To access the Port Level Security Configuration screen, use the arrow
keys to highlight the PORT LEVEL SECURITY CONFIGURATION
menu item on the Repeater Configuration Menu screen and press ENTER.
The Port Level Security Configuration screen displays.