Filter
Top Products
Swapping a Switch Module
FE Switch Module User Guide Page 6-3
6. Gently slide the new switch module into the plastic guides in the
module slot until it is completely inserted. Push the module firmly into
place, as far as it will go, to fully engage the connectors at the back of
the module with the backplane at the rear of the ATX chassis.
7. Tighten the screws on each side of the switch module’s front panel.
8. If you took the original module offlline by pressing the OFFLINE
button, the new switch module will automatically come back online
when it is inserted in the slot.
If you used the Local Console Manager
offline command to take the
original module offline, you must use the
online command to bring
the new module online.
9. Check the switch module LED power-on sequence as described in
Chapter 2, Connecting to the Network.
10. Make the connections to the network as described in Chapter 2.