Filter
Top Products
Operation
3-4
System Management Buses
There are two management channels within the SmartSwitch 9000 system: the
SMB-1 and the SMB-10. These buses provide side-band management and inter-
module management communication.
SMB-1 Bus
The SMB-1 is a 1Mbs management bus located within the SmartSwitch 9000. This
bus is utilized by all diagnostic controllers in the system including connectivity
modules, power supply modules and the environmental module. The SMB-1
transports inter-chassis information between system components, such as power
and environmental information, as well as diagnostic messages. Periodic loop-
back test are performed by all modules that share this bus to ensure the validity of
SMB-1. In the event a failure is detected on SMB-1, the SMB-10 may be used as an
alternate communication channel.
SMB-10 Bus
The SMB-10 is a 10Mbs management bus located within the SmartSwitch 9000.
This bus is used for inter-chassis communication of modules as well as serving as
an side-band management channel into the SmartSwitch 9000.
The SMB-10 is externalized from the chassis via an optional Ethernet Port
Interface Module (EPIM) located on the front of the Environmental Module.
Through an EPIM connection, full SNMP management of the SmartSwitch 9000 is
available side-band from user data. Modules that share the SMB-10 bus
periodically send out loop-back packets to ensure the validity of SMB-10. If a fault
is detected on the SMB-10, the SMB-1 can be used as an alternate communication
channel by the modules.
System Diagnostic Controller
This diagnostic controller is composed of a Z-80 microprocessor and its
supporting logic. The diagnostic controller is designed to control the power-up
sequencing of modules, monitor the module input and output power parameters,
keep watch over the main host processor, monitor the temperature, and control
the SMB LANVIEW diagnostic LEDs. Although the system diagnostic controller
and the main host processor can operate independently of each other if needed,
they exchange information about each others status and overall module
condition. The information gathered by the diagnostic controller is available to
the network manager via local/remote management and the LCD located on the
environment module. The module is designed to continue functioning in the
event of a diagnostic controller fault.