Filter
Top Products
2-1
Chapter 2
Installing the SmartSwitch 9000
Module
Unpacking the Module
1. Carefully remove the module from the shipping box. (Save the box and
packing materials in the event the module must be reshipped.)
2. Remove the module from the plastic bag. Observe all precautions to prevent
damage from Electrostatic Discharge (ESD).
3. Carefully examine the module, checking for damage. If any damage exists,
DO NOT install the module. Contact Cabletron Systems immediately.
Installing an HSIM or VHSIM
You can install an HSIM or VHSIM in any Cabletron Systems device that supports
HSIMs and VHSIMs. Refer to the release notes for the version of firmware
running on the Cabletron Systems device to ensure that the HSIM or VHSIM is
supported.
To install an HSIM or VHSIM in a module that supports HSIM/VHSIM
technology:
1. Disconnect all cables from the interface module. Note the ports to which these
cables attach.
Only qualified personnel should perform installation procedures.