Filter
Top Products
BRIM-A6 User’s Guide Page 2-1
CHAPTER 2
INSTALLATION
This chapter contains instructions for unpacking the BRIM, installing
APIMs, and installing the BRIM into Cabletron Systems devices that
support BRIM technology.
To install the BRIM and APIMs, you need the following tools:
• 1 disposable grounding wrist strap (provided with any MIM or hub)
• 1 Phillips-head screwdriver.
2.1 UNPACKING THE BRIM
Unpack the BRIM as follows:
1. Remove the shipping box material covering the BRIM.
2. Carefully remove the module from the shipping box. Leave the
module in its non-conductive bag until you are ready to install.
3. Attach the disposable grounding strap to your wrist (refer to the
instructions on the disposable grounding strap package).
4. After removing the module from its non-conductive bag, visually
inspect the device. If you notice any signs of damage, contact
Cabletron Systems Technical Support immediately.
!
CAUTION
The BRIM-A6 and the host MIM or hub are sensitive to static
discharges. Use a grounding strap and observe all static
precautions during this procedure. Failure to do so could result
in damage to the BRIM-A6 or the host MIM or hub.
book Page 1 Thursday, April 18, 1996 2:18 PM