Filter
Top Products
Chapter 2: Installation
Page 2-6 BRIM-A6 User’s Guide
5. Remove the faceplate mounting screws and the BRIM coverplate.
See Figure 2-2.
6. Remove the standoff screws. See Figure 2-2.
7. Place the BRIM behind the hub faceplate. See Figure 2-3.
8. Insert the connector pins of the BRIM-A6 into the BRIM connector on
the hub.
9. Press down firmly on the back of the BRIM-A6 until the pins slide all
the way into the connector holes.
10. Reinstall the faceplate mounting screws and the standoff screws.
11. Reattach the chassis cover to the hub, reconnect the power cord, and
reconnect the hub to your network.
12. Refer to Chapter 3 for instructions on configuring the BRIM-A6 using
Local Management.
NOTE
Ensure that the standoffs on the hub align with the standoff
screw holes on the BRIM.
Ensure that the chassis cover is in place before reconnecting
the power cord.
book Page 6 Thursday, April 18, 1996 2:18 PM