Filter
Top Products
9033029 Installation 7
2. INSTALLATION
Inspecting Your Shipment
When you receive the shipment of your switch, check the package
contents and make sure you have the following items:
• ELS100-8TXUF2 Fast Ethernet switch
• Mounting velcro
• Rubber feet
• Power adapter
• This document
Site Requirements
Before you install the switch, make sure the site meets the following
requirements:
• Mounting
Provide a flat table, wall or shelf surface.
• Power source
Provide a power source within six feet (1.8 m) of the installation loca-
tion. This source must provide 100 VAC to 240 VAC, and 50 Hz to 60
Hz power, with a 100 VA minimum. Power specifications for the
switch are shown in Appendix A, “Technical Specifications.”
• Environmental
Install the ELS100-8TXUF2 switch in a dry area, with adequate air
circulation. Avoid placing the switch in direct sunlight or near other
heat sources, such as hot-air vents. For temperature and humidity
specifications, see Appendix A, “Technical Specifications.”
• Ventilation
Do not restrict airflow by covering or obstructing air inlets on the side
of the switch.
ELS100-8TXUF2.book Page 7 Friday, June 4, 1999 4:01 PM