Filter
Top Products
ELS10-26 MIB
6-13
6.1.5 Addresses Configuration Group
The Addresses Configuration Group consists of the parameters
described below.
lxaddrStatics {lxaddr 1}
Counter Read-Only
The number of static addresses which are currently stored in the
ELS10-26.
lxaddrDynamics {lxaddr 2}
Counter Read-Only
The number of learned addresses in the ELS10-26’s address table.
lxaddrDynamicMax {lxaddr 3}
Gauge Read-Write
The maximum number of spanning tree addresses which have
been learned since the ELS10-26 was last booted (or this parameter
was last reset by the NMS).
lxaddrDynamicOverflows {lxaddr 4}
Counter Read-Write
The number times an address was not learned due to insufficient
address table space.
lxaddrFlags {lxaddr 5}
Integer Read-Write
Flags to describe the use and control of this address entry. Each bit
has a different meaning. The NMS must always set either
entry-static or entry-none; however, for GetRequests, the NMS will
see either no bits set (if the entry does not exist), or exactly one of
the following bits set:
• bit 29 is reserved.
• entry-static = 28, if set then this is a pre-defined customer
address, e.g., an IEEE Spanning Tree static address.