Filter
Top Products
CONNECTING THE FOT-F3 TO THE NETWORK
FOT-F3 USER’S MANUAL 3-5
c. Disconnect the device to which the transceiver is
attached.
d. Check the AUI connections for proper pinouts. The
pinouts for the transceiver connection are listed in
Appendix A.
e. Check the cable for continuity.
f. Reconnect the AUI cable to the FOT-F3 and the
device.
3. Move the slide lock on the AUI connector to secure it to the
lock posts on the port.
3.2.3 Connecting the Fiber Optic Cable
This section describes how to connect the fiber optic link
segment to the FOT-F3. Perform the following steps only after
testing the fiber optic cable to ensure that the cable has no
defects.
Note: It is recommended to label the fiber optic cable to indicate
which fiber is Receive and which is Transmit. When you buy
fiber optic cable from Cabletron Systems, at one end of the
cable, one fiber is labeled 1, and the other fiber is labeled 2. This
pattern is repeated at the other end of the cable. If you did not
purchase your cable from Cabletron Systems, then be sure you
have labeled your cable in the manner described above.