Filter
Top Products
Page 3 - 1
INSTALLATION
CHAPTER 3
INSTALLING THE FOT-F3
This chapter contains instructions for unpacking your
Cabletron Systems’ FOT-F3 Transceiver, connecting the
FOT-F3 to an Ethernet device and the network, installing
cable supports, and mounting the transceiver (if
necessary). Verify that all requirements listed in Chapter
2, Installation Requirements/Specifications, are met
before installing the transceiver.
3.1 UNPACKING THE FOT-F3
Before you install the FOT-F3, you should visually inspect
the transceiver and check the contents of the accessory
package. To unpack the transceiver:
1. Carefully remove the transceiver from the shipping
box. Save the shipping box and materials in the
event the transceiver has to be reshipped.
2. Remove the transceiver from its protective plastic bag
and set the transceiver aside.
3. Remove the accessory package from the box. It
should contain: