Filter
Top Products
Page 3 - 8
INSTALLATION
6. Check that the LNK LED on the FOT-F3 is lit. If the
LED is not lit, perform each of the following steps until
the LED is lit:
a. Check that the power is on for the device at the
other end of the link.
b. Verify that the fiber strands are properly
connected to each port.
c. Reverse the fiber optic cable ends at one end of
the fiber optic link segment.
If a link has not been established, contact Cabletron
Systems’ Technical Support.
3.3 MOUNTING THE FOT-F3
Using the contents of the accessory package, you can
mount the FOT-F3 on a surface close to the workstation or
on the workstation itself.
The surface you choose should meet the following
requirements:
• Allows the fiber optic segment to be easily connected
to the transceiver.