Cabletron Systems TRXI-22 Switch User Manual


 
INSTALLATION
Page 3-1
CHAPTER 3
INSTALLATION
This chapter outlines the procedure for installing a TRXI and
connecting it to a network. Be sure that your network meets the
guidelines and requirements outlined in Chapter 2,
Requirements/
Specifications
, before installing the TRXI.
3.1 UNPACKING THE TRXI
Unpack the TRXI as follows:
Remove the TRXI from the shipping box.
Slide the two foam end caps off the TRXI.
Remove the TRXI from the protective plastic bag and set it
aside to prevent damage.
Visually inspect the TRXI. If there are any signs of damage,
contact Cabletron Systems Technical Support immediately.
3.2 ATTACHING THE STRAIN RELIEF BRACKET
Attach the strain relief bracket to the front of the TRXI as follows:
1. Locate the strain relief bracket and four 8-32 x 3/8" screws from the
TRXI installation kit.
Caution
: Use of longer screws may cause damage to the unit or
electrical shock.