Filter
Top Products
56
Setting Scan Conditions
Setting in the User Mode
The DR-5060F allows you to select which of the following setup items is used as
the user mode.
Details are available on how to set the user mode. (See “How to Set the User
Mode” P. 58)
■ User Mode Setup Items
Operation panel buzzer setting
Sets whether or not to sound the buzzer when pressing keys on the operation
panel.
U1-0: Do not sound buzzer during key operation.
U1-1: Sound buzzer during key operation. (default)
Document detection setting
Sets the detection method when automatically detecting the document width.
U2-0: Detect document width by document width.
U2-1: Detect document width by paper guide width. (default)
Skew detection setting
Sets detection of skew when the document has skewed.
U3-0: Do not detect document skew. (default)
U3-1: Detect document skew, and stop document feed.
U3-2: Detect document skew, and stop document feed.
(excluding manual mode)
SCSI synchronization setting
Sets transfer of synchronization with the SCSI card.
U4-0: Do not transfer SCSI synchronization.
U4-1: Transfer SCSI synchronization (default)
Bar code setting
Set operation when a bar code is detected.
U5-0: Do not sound buzzer during bar code reading.
U5-1: Sound buzzer during bar code reading. (default)
U6-0: Output START/STOP codes in Codabar bar code in lower case.
(default)
U6-1: Output START/STOP codes in Codabar bar code in upper case.
U7-0: Do not verify bar code.
U7-1: Verify bar code once. (default)
U7-2: Verify bar code twice.
U7-3: Verify bar code three times.