Filter
Top Products
1 - 26
3-3-6 Applying White Sheet
(1) Rib bumps are provided on the right side and the bottom side of the FAU (Film Adapter Unit)
Protective Sheet. (See the photo shown below, the directions when you open the document cover.)
Temporally attach the white sheet to a place inside the rib bumps on the right side (about 1 mm
inside or less).
(2) Attach the whole part of the white sheet, by aligning the edge of the white sheet on the line of rib
bumps on the bottom side of the FAU Protective Sheet. (See the photo shown below, one line
inner from the outmost line.)
Figure1-17 Applying white Sheet
(3) Confirm the location to apply the white sheet. For the confirmation, lift up the document cover
just a little, and look into to visually confirm that the edges of the white sheet are not placed on the
scanner top cover (molded part).
OK Example: The edges of the white sheet are not located on the scanner top cover.
Figure1-18 Location confirmation to apply the white sheet (the rear side and the right side) (OK
example)
White Sheet Corners
White sheet
FAU Protective Sheet
Rib on the
right
Rib