Filter
Top Products
68
When the projection lamp of the projector
reaches its end of life, the Lamp replacement
icon appears on the screen and LAMP
REPLACE indicator lights yellow. Replace the
lamp with a new one promptly. The timing when
the LAMP REPLACE indicator should light is
depending on the lamp mode.
Follow these steps to replace the
lamp.
For continued safety, replace with a lamp of the
same type. Do not drop a lamp or touch a glass
bulb! The glass can shatter and may cause
injury.
Allow a projector to cool for at least one hour
before you open the Lamp Cover. The inside
of the projector can become very hot.
Unplug the AC power cord. Let the projector
cool for at least one hour.
Loosen the three (3) screws that secure the
lamp. Lift the lamp out of the projector by
using the handles.
1
3
Replace the lamp with a new one and
secure the three (3) screws. Make sure that
the lamp is set properly. Close the lamp
cover and secure the screw.
4
Loosen the screw and open the lamp cover.
2
Connect the AC power cord to the projector
and turn on the projector.
5
LAMP
REPLACE
Screw
Handles
Screw
Lamp Cover
Screw
Screw
When replacing the lamp because it has stopped illuminating, there is a possibility that the lamp
may be broken.
If replacing the lamp of a projector which has been installed on the ceiling, you should always
assume that the lamp is broken, and you should stand to the side of the lamp cover, not
underneath it. Remove the lamp cover gently. Small pieces of glass may fall out when the lamp
cover is opened. If pieces of glass get into your eyes or mouth, seek medical advice immediately.
• The image will be displayed for about 10 seconds.
• The Lamp replacement icon will not appear when the Display function is set to (p.53), during (p.28),
or (p.29).
OK
POWER
AUTO S ET
MENU
LAMP REPLACE
WARNING
VOLVOL
See "Lamp Counter" on page 62.
6
Lamp