E-21
Initializing the Label Printer
If you experience serious malfunction of the Label Printer or if operation fails
completely, try performing the following operation to initialize the printer.
Important!
• Initializing the Label Printer deletes all memory contents. Make sure you have
a back-up copy of text stored in memory if you need it.
To initialize the Label Printer
1. Turn power off.
2. While holding down the PRINT and ESC keys, press ON/OFF to turn power
on.
3. Keeping PRINT and ESC held down, release the ON/OFF key only.
• This prompt confirms whether or not you want to initialize the Label Printer.
4. Release ESC, and then PRINT.
INITIAL?
5. Press SET to initialize the Label Printer or ESC to abort the reset operation.
• The following table shows the initial settings.
Troubleshooting
•
Power Supply
•
Text Input
Low batteries
Improper display contrast
setting
Batteries loaded
incorrectly
AC adaptor is not
connected correctly.
Replace batteries.
Adjust display contrast.
Remove batteries and reload them
correctly.
Make sure the AC adaptor is
connected correctly.
Nothing appears on the display.
Possible Causes Action Page
Item
Display
Memory
Preset
Phrases
SYMBOL
SIZE
EFFECT
STYLE
M-FEED
MIRROR
MEMO
DENSITY
CONTRAST
Reset
Cleared
Cleared
PHRASE
REGISTERED
,
AUTO
CANCEL
NORMAL
NO
OFF
STORE
3
Level 16
E-6
E-20
E-6
E-6
FUNC key has been
pressed.
Press ESC to clear FUNC key
operation.
Cannot input text.
Possible Causes Action Page
E-9