Filter
Top Products
30
2.5 DIP Switch Setting for HA-A61IO
The DIP switch is located on the rear side of the Bridge Satellite Cradle. Change the ON/OFF settings according to
your required system configuration. The new settings do not go into effect until the power switch is turned off and
then back on again.
Not used (Always set to "OFF")
Not used (Always set to "OFF")
Host computer interface
Interface 6
RS-232C OFF
USB * ON
Termination setting for daisy chain connection
Termination 5
At middle OFF
No chain/Termination* ON
Connection mode
Mode 3 4
With Host PC* OFF OFF
Chain connection ON OFF
Communication speed between Cradles
Baud rate 1 2
115,200bps * ON OFF
ON（Upper side）
OFF（Lower side）
Note:
Other DIP switch settings are used for testing and inspection purposes. Because of this, you should never use any
DIP settings other than those described above.
Fig. 2.3
* : Default setting.