Filter
Top Products
4. Operating Instructions 10 1/13/2011 5:38 PM
Master/Slave Mode (Sound-Active)
This mode allows a single unit, the master, to operate in either automatic or sound-active mode.
When additional (slave) fixtures are daisy chained to the master, they will all synchronize with the
master and run the same lighting show.
Please see the instructions below for details on this mode.
Master:
1. Place the master fixture first in the daisy chain.
2. Set the master fixture to operate in either automatic or sound-active mode; please see
the appropriate sections of this manual for details on this procedure.
Slave:
1. Daisy chain from the output of the master fixture.
2. Press <MODE> until SLAU appears on the LED screen.
Plug the master fixture in LAST!
Only connect 31 slave fixtures when operating in this mode!
Using the “Invert” function will invert any fixture(s) it is active on. This is useful when you
desire to have symmetry to your lighting show. Please see the “Menu Map” for further
details.
Standalone
Sound-Active
Please see the instructions below for details on this mode.
1. Plug the fixture into power.
2. Press <MODE> until SoUd appears on the LED screen.
3. Press <ENTER>.
4. Use the microphone sensitivity adjustment knob to adjust the fixture to react to the beat
of the music.
5. Press <ENTER>.
The microphone will only respond to low frequencies (bass).
Automatic
Please see the instructions below for details on this mode.
1. Plug the fixture into power.
2. Press <MODE> until AUTO appears on the LED screen.
3. Press <ENTER>.
4. Using <UP>&<DOWN>, adjust the program speed (S_ _1~S100) (fast~slow).
5. Press <ENTER>.