Filter
Top Products
11
DHD800 User Manual
020-000244-01 Rev.1 (08-2010)
Terminals and Connectors
R/C JACK
When using the wired remote control, connect the
wired remote control to this jack with a remote
control cable (not supplied).
DUSB CONNECTOR (Series B)
USB connector is used to service the projector.
HS-VIDEO INPUT JACK
Connect the S-VIDEO output signal from video
equipment to this jack. (p.21)
<
SERIAL PORT IN TERMINAL
If you control the projector through RS-232C
from a computer, you must connect a cable (not
supplied) from your computer to this terminal.
B
SERIAL PORT OUT TERMINAL
This terminal outputs signal from SERIAL PORT
IN. More than two projectors can be controlled
through RS-232C from one computer by
connecting SERIAL PORT IN of another projector
to this terminal.
J5 BNC INPUT JACKS
Connect the component or composite video
output signal from video equipment to VIDEO/Y,
Pb/Cb, and Pr/Cr jacks or connect the computer
output signal (5 BNC Type [Green, Blue, Red, Horiz.
Sync, and Vert. Sync.]) to G, B, R, H/V, and V jacks.
(pp.20–21)
DJ E GL
<
G
DVI INPUT TERMINAL
Connect computer output (Digital/DVI-D type) to
this terminal. (p.20)
HDTV (HDCP Compatible) signal can be also
connected. (p.21)
8
D-sub 15-PIN INPUT TERMINAL
Connect computer output (Analog D-sub 15-pin
type) to this terminal. (pp.20-21)
Part Names and Functions
LHDMI
Connect the HDMI output signal from video
equipment to this terminal. (p.21)
E
MONITOR OUT TERMINAL
This terminal can be used to output the incoming
analog RGB, component, or composite video
out signals from INPUT 1-2 terminal to the other
monitor. (pp.20-21)
8
B
H
LAN port
Connecting the Ethernet cable. See the owner's
manual of “Network Set-up and Operation” for
details.