Filter
Top Products
31
Cisco TelePresence PrecisionHD Camera PrecisionHD Camera User guide
D14640.09 PrecisionHD 1080p-720p Camera User Guide, June 2012.
© 2010-2012 Cisco Systems, Inc. All rights reserved.
www.cisco.com
The VISCA™/RS–232 control
protocol, cont...
NOTE: The information on this page applies to PrecisionHD
Camera 1080p12x only.
Video mode selection
The DIP switch selection has priority over the selection made
by the CAM_Video_Format command. If the DIP switch is set
to auto, the CAM_Video_Format setting will be used. If both
are set to auto, resolution will be controlled automatically by
EDID.
DIP Switch settings
Switches are numbered 1 to 5. The VISCA column shows the
value that must be used when using the CAM_Video_Format
command.
NOTE: The DIP switches are only read by the SW at startup/
boot. So if the DIP switches are changed the camera must be
rebooted.
If an undened mode is selected, the output will default to auto.
DIP Switch table for VISCA commands and video output formats
1 2 3 4 5 VISCA HDMI HD-SDI
0 0 0 0 0
x
Auto
*
0 0 0 0 1
0x0000 1080p25 1080p25
0 0 0 1 0
0x0001 1080p30 1080p30
0 0 0 1 1
0x0002 1080p50 720p50
0 0 1 0 0
0x0003 1080p60 720p60
0 0 1 0 1
0x0004 720p25 720p25
0 0 1 1 0
0x0005 720p30 720p30
0 0 1 1 1
0x0006 720p50 720p50
0 1 0 0 0
0x0007 720p60 720p60
0 1 0 0 1
0x0009
SW control
The table shows the dierent settings
available for the HDMI and the HD-SDI
outputs.
Auto: Camera negotiates format over
HDMI. HD-SDI tracks HDMI and defaults
to 1080p30 in absence of HDMI sync.
Software: Used when controlling
cameras using the VISCA protocol.
DIP switch table
PrecisionHD 1080p12x, from below
The DIP switches 1 to 5
0 1
Contents
Appendices
Introduction
The physical interface
Connecting the camera
Video output formats
Daisy chaning
Appendices