Filter
Top Products
29
Cisco TelePresence PrecisionHD Camera PrecisionHD Camera User guide
D14640.09 PrecisionHD 1080p-720p Camera User Guide, June 2012.
© 2010-2012 Cisco Systems, Inc. All rights reserved.
www.cisco.com
Command Command
Packet
Response
Gamma_Mode_Inq 8x 09 04 51 Resp: y0 50 0p
p=2: Auto, p=3: Manual
Gamma_Table_Inq 8x 09 04 52 Resp: y0 50 0p 0q 0r 0s
pqrs: Gamma table in use if manual mode.
Call_LED_Inq 8x 09 01 33 01 Resp: y0 50 0p
p=2: On, p=3: O, p=4: Blink
Power_LED_Inq 8x 09 01 33 02 Resp: y0 50 0p
p=2: On, p=3: O
Video_System_Inq 8x 09 06 23 y0 50 0p 0q 0r 0s
pqrs=video mode currently being output on
the HDMI port. See chapter on DIP switches.
DIP_Switch_Inq * 8x 09 06 24 y0 50 0p 0q 0r 0s pqrs contains the bit
pattern of the DIP switch. See chapter on
DIP switches.
IR_Output_Inq 8x 09 06 08 Resp: y0 50 0p
p=2: On, p=3: O
ALS_RGain_Inq * 8x 09 50 50 Ambient Light Sensor Resp: y0 50 0p 0q 0r
0s 0t 0u 0v 0w
pqrstuv=32 bit unsigned integer, relative gain
value. The integration time is a constant set in
the camera SW.
ALS_BGain_Inq * 8x 09 50 51
ALS_GGain_Inq * 8x 09 50 52
ALS_WGain_Inq * 8x 09 50 53
Up side down_Inq
*
8x 09 50 70 Resp: y0 50 0p
p=0: Camera is upright.
p=1: Camera is upside down.
Command Command
Packet
Response
CAM_ID_Inq 8x 09 04 22 Resp: 90 50 zz xx 00 yy
Only zz, which identies the camera, is
relevant. zz = 0x50 for this camera.
CAM_SWID_Inq 8x 09 04 23 Resp: y0 50 [1-125 bytes ASCII SWID] . Never
route this message through Sony cameras.
CAM_HWID_Inq 8x 09 04 24 The response is the Module Serial Number
stored in EEPROM. The number is converted
to ASCII : y0 50 [12 bytes ASCII HWID] .
Zoom_Pos_Inq 8x 09 04 47 Resp: y0 50 0p 0q 0r 0s
pqrs: zoom position
Focus_Pos_Inq 8x 09 04 48 Resp: y0 50 0p 0q 0r 0s
pqrs: focus position
Focus_Mode_Inq 8x 09 04 38 Resp: y0 50 0p
p=2: Auto, p=3: Manual
PanTilt_Pos_Inq 8x 09 06 12 Resp: y0 50 0p 0q 0r 0s 0t 0u 0v 0w
pqrs: pan position tuvw:
tilt position
Power_Inq 8x 09 04 00 Resp: y0 50 0p
p=2: On, p=3: O
WB_Mode_Inq 8x 09 04 35 Resp: y0 50 0p
p=0: Auto , p=6: Table manual
WB_Table_Inq 8x 09 04 75 Resp: y0 50 0p 0q 0r 0s
pqrs: Table used if table mode
AE_Mode_Inq 8x 09 04 39 Resp: y0 50 0p
p=0: Auto, p=3: Manual
Backlight_Mode_
Inq
8x 09 04 33 Resp: y0 50 0p
p=2: On, p=3: O
Mirror_Inq 8x 09 04 61 Resp: y0 50 0p
p=2: On, p=3: O
Flip_Inq 8x 09 04 66 Is video ipped or not?
Resp: y0 50 0p
p=2: On , p=3: O
The VISCA™/RS–232 control protocol, cont...
Inquiries
NOTE: Some VISCA™ commands do not apply to the PrecisionHD 1080p4x/4xS2 cameras.
* Do not apply to PrecisionHD 4x/4xS2 cameras
Contents
Appendices
Introduction
The physical interface
Connecting the camera
Video output formats
Daisy chaning
Appendices