Filter
Top Products
2
Quick Start Guide for Cisco Digital Media Encoder 1100
OL-17934-01
Connecting to an Electrical Power Source
Note There are advanced setup options of the encoder that you will need to modify before running an encoder
session. You will use the Niagara SCX® Web Interface to access these options. Refer to the User Guide
for Cisco Digital Media Encoder 1100 for detailed instructions.
Connecting to an Electrical Power Source
Figure 2 shows the rear panel of the encoder.
Figure 2 Rear Panel
Using the reference chart and images in Table 1, you can connect the appropriate device and power to
the encoder.
190000
Table 1 Rear Panel Power Connections
Connection Description
AC Power connector for 100-240
volts, AC, 50-60 Hz
Plug the power cable that was include with your encoder to
this connector and plug the opposite end into an AC power
source or electrical wall outlet.