2-5
Catalyst 2900 Series XL Hardware Installation Guide
78-6461-03
Chapter 2 Installation
Preparing for Installation
Hungary
This equipment is a class A product and should be used and installed properly
according to the Hungarian EMC Class A requirements (MSZEN55022). Class A
equipment is designed for typical commercial establishments for which special con-
ditions of installation and protection distance are used.
Figyelmeztetés a felhasználóikézikönyv számára:
Ez a berendezés “A” osztályú termék, felhasználására és üzembe helyezéséreamag-
yar EMC “A” osztályú követelményeknek (MSZ EN 55022) meg
feleloen kerülhet
sor, illetve ezen “A” osztályú berendezések csak megfelelo kereskedelmi forrásból
származhatnak, amelyek biztosítják a megfelelo speciális üzembe helyezési
körülményeket és biztonságos üzemelési távolságok alkalmazását.
Installation Guidelines
The switch can be installed on a table or shelf, in a rack, or on a wall.
Before installing the switch, first verify that the switch is operational by powering
it on and running POST. Follow the procedures in the “Powering On the Switch
andRunningPOST” section on page 2-25.
Caution There are no serviceable parts inside the unit. Removing screws, cover, or
otherwise dismantling the unit voids the warranty.
Warning
Unplug the power cord before you work on a system that does not have an
on/off switch.
When determining where to place the switch, be sure to observe these guidelines:
• For 10/100 ports, cable lengths from the switch to connected devices are up
to 328 feet (100 meters).
• For 100BASE-FX ports, cable lengths from the switch to connected devices
are up to 1351 feet (412 meters) for half-duplex connections and less than
6561 feet (2 kilometers) for full-duplex connections.
