Filter
Top Products
4
Cisco 2800 Series and Cisco 3800 Series Integrated Services Routers Regulatory Compliance and Safety Information
OL-10258-02
Agency Compliance
Compliance with FCC Part 68 Requirements
This equipment complies with Part 68 of the FCC rules. On the bottom of the chassis is a label that
contains, among other information, the FCC registration number and ringer equivalence number (REN)
for this equipment. If requested, this information must be provided to the telephone company.
If this equipment causes harm to the telephone network, the telephone company will notify you in
advance that temporary discontinuance of service may be required. If advance notice is not practical, the
telephone company will notify the customer as soon as possible. Also, you will be advised of your right
to file a complaint with the FCC if you believe it is necessary.
The telephone company may make changes in its facilities, equipment, operation, or procedures that
could affect the operation of this equipment. If this happens, the telephone company will provide
advance notice in order for you to make the necessary modifications to maintain uninterrupted service.
Normally, this equipment will be used in conjunction with FCC registered equipment that limits the
Encoded Analog Content that provides the required Billing Protection. If the connected equipment is not
of this type, an affidavit must be supplied to the telephone company where the network connection is to
be made. The affidavit is to be notarized, and is to be filed at least ten days before the initial connection.
The facility interface and service order codes are shown in Table 2.
Cisco 2800 series and Cisco 3800 series integrated services routers bearing labeling identification
number US:5B1IS10B0043 comply with the following requirements:
• FCC Rules and Regulations 47 CFR Part 68
• TIA-968-A, Telecommunications Telephone Terminal Equipment Technical Requirements for
Connection of Terminal Equipment to the Telephone Network, October 2002, as adopted by the
Administrative Council on Terminal Attachments (ACTA)
See Figure 1 on page 6 for the Cisco Supplier Declaration of Conformity. This document is also
available online at: http://www.cisco.com/warp/customer/508/dofc/361003.pdf.
Table 2 Cisco 2800 Series and Cisco 3800 Series Integrated Services Routers Facility Interface and
Service Order Codes
Interface Type Facility Interface Code (FIC)
Service Order
Code (SOC) Jack Type (USOC)
ADSL
1
Metallic — RJ-11C
SHDSL Metallic — RJ-11C
RJ-14C
BRI-S/T 02IS5 6.0N RJ-49C via NT1
BRI-U 02IS5 6.0N RJ-49C
T1 data 04DU9-BN
04DU9-DN
04DU9-1KN
04DU9-1SN,
6.0N RJ-48C
T1 voice 04DU9-BN
04DU9-DN
04DU9-1KN
04DU9-1SN,
04DU9-1ZN
6.0Y RJ-48C
FXO
1
02LS2
02GS2
—RJ-11C
RJ-21X