Filter
Top Products
11
Warning
Attach only the Cisco RPS (model PWR600-AC-RPS) to the RPS receptacle. To see translations of the warnings that
appear in this publication, refer to the Regulatory Compliance and Safety Information document that accompanied
this device.
Warning
Before performing any of the following procedures, ensure that power is removed from the DC circuit. To ensure
that all power is OFF, locate the circuit breaker on the panel board that services the DC circuit, switch the circuit
breaker to the OFF position, and tape the switch handle of the circuit breaker in the OFF position. To see
translations of the warnings that appear in this publication, refer to the Regulatory Compliance and Safety
Information document that accompanied this device.
Warning
Before working on a system that has an on/off switch, turn OFF the power and unplug the power cord. To see
translations of the warnings that appear in this publication, refer to the Regulatory Compliance and Safety
Information document that accompanied this device.
Warning
This unit might have more than one power cord. To reduce the risk of electric shock, disconnect the two power
supply cords before servicing the unit. To see translations of the warnings that appear in this publication, refer to
the Regulatory Compliance and Safety Information document that accompanied this device.
To connect an external hub, switch, router, or concentrator to a Cisco RPS, perform the following steps:
Step 1 Disconnect the AC power cord on a hub or switch; turn the power switch to the OFF position on a router or
concentrator.
Step 2 Connect the DC-output end of the cable to the RPS connector on the rear panel of the hub, switch, router, or
concentrator. The DC-output end of the RPS cable has either 8 or 18 pins in the connector. (For connector locations,
see Figure 10 through Figure 13.)
Figure 10 RPS Connector Location on a Cisco Hub (Typical)
11537
RS-232
Serial port
Cisco RPS
connector
Reset
switch
AC power
connector