Filter
Top Products
4
2 Verifying the Module Installation
Verify that the switch acknowledges the ASASM and has brought it online. (If you need to install your
ASASM, see the module installation guide on Cisco.com.) Enter the following command to ensure that
the Status column shows “Ok” for the ASASM:
show module [switch {1 |2}] [mod-num | all]
For a switch in a VSS, enter the switch argument.
For example:
Router# show module
Mod Ports Card Type Model Serial No.
--- ----- -------------------------------------- ------------------ -----------
2 3 ASA Service Module WS-SVC-ASA-SM1 SAD143502E8
Mod MAC addresses Hw Fw Sw Status
--- ---------------------------------- ------ ------------ ------------ -------
2 0022.bdd4.016f to 0022.bdd4.017e 0.201 12.2(2010080 12.2(2010121 Ok
...
3 Assigning VLANs to the ASA Services Module
The ASASM does not include any external physical interfaces. Instead, it uses VLAN interfaces passed
down from the supervisor. Perform the following steps at the switch CLI to pass down VLANs from
the supervisor:
Command Purpose
Step 1
firewall vlan-group firewall_group_num vlan_range
Example:
Router(config)# firewall vlan-group 50 55-57
Router(config)# firewall vlan-group 51 58-63
Router(config)# firewall vlan-group 52 64,66-74
Assigns VLANs to a firewall
group.
Step 2
firewall [switch {1 |2}] module module_number
vlan-group firewall_group_num
Example:
Router(config)# firewall module 5 vlan-group 50,52
Router(config)# firewall module 8 vlan-group 51,52
Assigns the firewall groups to the
ASASM
. For a switch in a VSS,
enter the switch argument.