Filter
Top Products
3-14
Cisco 860 Series and Cisco 880 Series Integrated Services Routers Hardware Installation Guide
OL-16193-01
Chapter 3 Connecting the Router
Connecting an FXS line
Step 3 Snap the latches into the holes on either side of the power connector. See Figure 3-11.
Figure 3-11 Power Lock Clip Latched Into the Holes on Either Side of the Power Connector
Connecting an FXS line
Use a standard straight-through RJ-11 modular telephone cable to connect an Foreign Exchange Service
(FXS) port to a telephone or fax machine.
Warning
This equipment contains a ring signal generator (ringer), which is a source of hazardous voltage. Do
not touch the RJ-11 (phone) port wires (conductors), the conductors of a cable connected to the RJ-11
port, or the associated circuit-board when the ringer is active. The ringer is activated by an incoming
call.
Warning
For connections outside the building where the equipment is installed, the following ports must be
connected through an approved network termination unit with integral circuit protection: FXS.
1 Power lock clip 2 Power cord
3 Power adapter 4 AC plug
270800
1
2
4
3