Filter
Top Products
10
Installing Hard Disk Drives in the Cisco Wide Area Application Engine 611
78-17404-01
Obtaining Documentation
To complete your installation, follow these steps:
Step 1 Install the cover. Place it into position, slide it forward, and then tighten the captive screw (labeled 1 in
Figure 2).
Caution Before sliding the cover forward, make sure that the cover will properly engage the ledge at the front of
the device.
Step 2 Install the bezel, as follows:
a. Align the hooks on the bottom of the bezel with the device.
b. Press the bezel toward the device until it clicks into place.
Step 3 Install the device in the rack. See the Cisco Wide Area Application Engine 511 and 611 Hardware
Installation Guide for instructions.
Step 4 Connect all external cables and the power cord to the device, and then plug the power cord into a properly
grounded electrical outlet.
Obtaining Documentation
Cisco documentation and additional literature are available on Cisco.com. Cisco also provides several
ways to obtain technical assistance and other technical resources.
You can access the most current Cisco documentation at this URL:
http://www.cisco.com/techsupport
You can access the Cisco website at this URL:
http://www.cisco.com
You can access international Cisco websites at this URL:
http://www.cisco.com/public/countries_languages.shtml
Cisco Product Security Overview
Cisco provides a free online Security Vulnerability Policy portal at this URL:
http://www.cisco.com/en/US/products/products_security_vulnerability_policy.html
From this site, you can perform these tasks:
• Report security vulnerabilities in Cisco products.
• Obtain assistance with security incidents that involve Cisco products.
• Register to receive security information from Cisco.
A current list of security advisories and notices for Cisco products is available at this URL:
http://www.cisco.com/go/psirt