Filter
Top Products
9
Caution Ensure that the captive screws are secured tightly prior to loading the handles to prevent injury or damage to the
chassis.
Figure 4 Attaching the Chassis Installation Handles to the Cisco RFGW-10 UEQAM
After the chassis rack-mount brackets are installed, additional handles can be installed onto the front of the rack-mount
brackets. The rack-mount brackets allow a low and high installation of the handles onto the bracket depending on the chassis
installation (low or high in the rack).
Attaching the Chassis Rack-mount Brackets
This section explains how to attach the front and the mid rack-mount brackets to the chassis. Before installing the chassis in the
rack, you must install the rack-mount brackets on each side of the chassis.
Note The rear RF cable management bracket is installed on the chassis after you install the chassis rack-mount brackets and
mount the chassis in the rack.
Chassis Front Rack-mount Brackets Installation
To install the front rack-mount brackets on a Cisco RFGW-10 UEQAM, complete the following steps:
273450