Filter
Top Products
Command Reference
20
Release 12.0(1)T
default-router
To specify the default router list for a Dynamic Host Configuration Protocol (DHCP) client, use
the default-router DHCP pool configuration command. Use the no form of this command to
remove the default router list.
default-router address [address2 ... address8]
no default-router
Syntax Description
Defaults
None
Command Modes
DHCP pool configuration
Usage Guidelines
This command first appeared in Cisco IOS Release 12.0(1)T.
The IP address of the router should be on the same subnet as the client subnet. You can specify up
to eight routers in the list. Routers are listed in order of preference (address1 is the most preferred
router, address2 is the next most preferred router, and so on).
Examples
The following example specifies 10.12.1.99 as the IP address of the default router:
default-router 10.12.1.99
Related Commands
ip dhcp pool
address Specifies the IP address of a router. One IP address is required,
although you can specify up to eight addresses in one command line.