Filter
Top Products
4-6
Installation and Upgrade Guide for Cisco Unified MeetingPlace Express Release 1.1
OL-6665-04
Chapter 4 Installing Cisco Unified MeetingPlace Express Release 1.1.2
Preinstallation Work
Step 6 When the value is Enhanced, the system displays a sub menu with two options. Highlight SATA RAID
Enable by using the up and down arrow keys.
Step 7 Use the left and right arrow keys to change its value to Enabled.
Step 8 Press Escape to exit the Advanced Chipset Control.
Step 9 Press Escape to exit Devices and I/O Ports.
Step 10 From the main menu, highlight Save Settings by using the up and down arrow keys. Press Enter to select
it.
Step 11 Press Enter to continue.
Step 12 Highlight Exit Setup by using the up and down arrow keys. Press Enter to select it.
Step 13 Select Yes, exit the Setup Utility and press Enter. The system automatically reboots.
Step 14 When prompted, press Ctrl-A to go to the Adaptec RAID Configuration Utility.
Step 15 Highlight Array Configuration Utility by using the up and down arrow keys. Press Enter to select it.
Step 16 From the main menu, select Initialize Drives by using the up and down arrow keys. Press Enter to select
it.
Step 17 Press the space bar to select both drives. Both drives appear in the Selected Drives box. Press Enter to
complete the selection.
Step 18 The system displays a warning message. Press y to continue.
Step 19 From the main menu, select Create Array by using the up and down arrow keys. Press Enter to select it.
Step 20 Press the space bar to select both drives. Both drives appear in the Selected Drives box. Press Enter to
complete the selection.
Step 21 In the Array Properties box, for Array Type, select RAID 1 (Mirror) and press Enter.
Step 22 Leave the Array Label blank and press Enter.
Step 23 Select Quick Init and press Enter.
Step 24 Press Enter again to accept.
Step 25 The system displays a message. Press any key to continue.
Step 26 The system displays the main menu. Press Escape to go back to the Adaptec RAID Configuration Utility
menu.
Step 27 Press Escape to exit the utility.
Step 28 The system displays a warning message. Select yes and press Enter. The system automatically reboots.
Configuring RAID on a Cisco MCS 7835 Series, a Cisco MCS 7845-I1-RC1, or a
Cisco MCS 7845H-3.0-IPC1
Note This topic only applies to the Cisco MCS 7835 series, Cisco MCS 7845-I1-RC1, and the Cisco MCS
7845H-3.0-IPC1 for all releases of Cisco Unified MeetingPlace Express.