Filter
Top Products
3
Cisco ME 3600X-24CX Switch Getting Started Guide
OL-27508-01
Initial Setup
Initial Setup
You need this equipment:
• PC
• Straight-through or crossover Category 5 Ethernet cable
Step 1
Obtain this information from your network administrator before you start the setup program:
• Switch IP address
• Subnet mask (IP netmask)
• Default gateway (router)
• Enable secret password
• Enable password
• Telnet password
Step 2
Connect the adapter cable to the console connector on the
switch front panel. Connect the other end of the cable to the
Ethernet port on your DHCP-enabled PC.
You must supply the console cable if you did not order one with
your switch.
Step 3
Start a terminal-emulation application such as Hyperterminal or ProcommPlus.
Step 4
Configure the baud rate and character format of the PC or
terminal to match these console port default characteristics.
• 9600 baud
• 8 data bits
• 1 stop bit
• No parity
• None (flow control)
Step 5
Power the switch.
AC power switches: Plug the AC power cord into the switch power supply and into a grounded AC outlet. Set the
power supply switch to ON.
DC power switches: See the wiring instructions in the hardware installation guide on Cisco.com.
333305