Filter
Top Products
5
Cisco ME 3600X-24CX Switch Getting Started Guide
OL-27508-01
Initial Setup
Step 6
(Optional) Configure Simple Network Management Protocol (SNMP) by responding to the prompts. You can also
configure SNMP later through the CLI. To configure SNMP later, enter no.
Configure SNMP Network Management? [no]: no
Step 7
At the prompt, enter either FastEthernet0 or the VLAN name (usually VLAN1) as the interface connected to the
management network, and press Return.
Enter interface name used to connect to the
management network from the above interface summary: FastEthernet0
Step 8
Enter Yes after the prompt, and then enter the
switch IP address and subnet mask. Press
Return.
The IP address and subnet mask shown to the
right are examples.
Configuring interface vlan1:
Configure IP on this interface? [yes]: yes
IP address for this interface: 10.4.120.106
Subnet mask for this interface [255.0.0.0]: 255.0.0.0
Step 9
Enter N when the prompt asks if you want to
enable the switch as a cluster command switch.
This switch will be a standalone switch that
does not support clustering.
Would you like to enable as a cluster
command switch? [yes/no]: no
The switch displays its initial configuration, as
shown on the right.
The following configuration command script was created:
hostname switch1
enable secret 5 $1$Ulq8$DlA/OiaEbl90WcBPd9cOn1
enable password enable_password
line vty 0 15
password terminal-password
no snmp-server
!
no ip routing
!
interface Vlan1
no shutdown
ip address 10.4.120.106 255.0.0.0
!
interface FastEthernet0/1
!
interface FastEthernet0/2
...<output abbreviated>
interface FastEthernet1/0/3
!
interface GigabitEthernet0/1
!
interface GigabitEthernet0/2
!
end
Step 10
These choices appear:
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
If you want to save the configuration and use it the next time the switch reboots, save it in
NVRAM by selecting option 2.
Enter your selection [2]:2
Make your selection, and press Return.