Filter
Top Products
Configuring Frame Relay Service
Cisco MGX 8850 Installation and Configuration, Release 1.1.00, Part Number 78-6186-02
6-32
• mastership indicates if this end of the connection is master or slave: 1=master,
2=slave.
• connID is the connection identifier at the remote end. It appears in the syntax as an
optional parameter because it is mandatory only when you add the connection at the
master end. See “Rules for Adding Connections” at the beginning of this chapter.
connID can have one the following formats according to the slave endpoint:
Nodename.SlotNo.PortNo.DLCI
Nodename.SlotNo.PortNo.ControllerId.DLCI
Nodename.SlotNo.PortNo.VPI.VCI for ATM endpoint
• controllerID is a number indicating the type of network control application:
1=PAR, 2=PNNI, 3=MPLS
For AX-FRSM-8T1 and AX-FRSM-8E1:
addcon <port> <DLCI> <cir> <chan_type> [CAC] <controller_type> <mastership>
<connID> <controllerID>
• port is the logical port number in the range 1–192 for T1 or 1–248 for E1. (See
addport step if necessary.)
• DLCI is the DLCI number in the range 0–1023.
• cir is the committed information rate in one of the following ranges:
for T1, 0–1536000 bps for T1; for E1, 0–2048000 bps.
• chan_type specifies the type of connection: 1=NIW, 2=SIW-transparent mode;
3=SIW with translation; 4=FUNI, and 5=frame forwarding.
• CAC optionally enables connection admission control: 1=enable. 2=disable (default).
• controller_type is the controller type for signaling: 1=PVC (PAR), the default,
2=SPVC (PNNI).
• mastership indicates if this end of the connection is master or slave: 1=master,
2=slave.
• connID is the connection identifier at the remote end and can have one the following
formats according to the type of card at the slave endpoint:
NodeName.SlotNo.PortNo.DLCI
NodeName.SlotNo.PortNo.ControllerId.DLCI
NodeName.SlotNo.PortNo.VPI.VCI for ATM endpoint
If the remote end is a PXM, the port number can be in the range 1–32 for user
connections or 34 for inband management connections (stand-alone node only).
• controllerID is a number indicating the type of network control application:
1=PAR, 2=PNNI, 3=TAG.
For MGX-FRSM-HS1/B:
addcon <port_number> <DLCI> <CIR> <chan_type> <CAC> <Controller_type>
<mastership> <connID>
• port_number is the logical port in the range 1–4.
• DLCI is the DLCI in the range 0–1023.