Filter
Top Products
CHAPTER
3-1
Cisco 10000 Series Router Service Selection Gateway Configuration Guide
OL-4387-02
3
SSG Logon and Logoff
The Cisco 10000 series router supports the following SSG features for logon and logoff related
functions:
• Single Host Logon, page 3-1
• SSG Autologoff, page 3-2
• SSG Prepaid Idle Timeout, page 3-3
• SSG Session and Idle Timeout, page 3-6
This chapter describes each of SSG logon and logoff features.
Single Host Logon
The Single Host Logon feature enables users to enter authentication information only twice. To log on
to a service through the SESM web application, a subscriber enters authentication information once for
the PPP session and once for the service. The subscriber does not have to log on to the SESM. Instead,
the SESM uses the PPP authenticated information from the SSG.
For non-PPP users, when a subscriber authenticates using the SESM application, the subscriber does not
have to log on again for the remainder of the non-PPP session. However, the subscriber still has to log
on to services. For more information, refer to Cisco Subscriber Edge Services Manager and Subscriber
Policy Engine Installation and Configuration Guide.
Prerequisites for Single Host Logon
To use the Single Host Logon feature, you must install and configure Cisco SESM Release 3.1(1) or later.