Filter
Top Products
6-8
Cisco Info Center Installation and Configuration Guide, 3.6.1
OL-6349-01
Chapter 6 Desktop Info Servers
Installing a Dual Server Desktop Architecture
Prompts for Configuring the DSD Architecture with SSL Configuration
Table 6-2 summarizes the OINSTALL installation prompts for SSL configuration in conjunction with a
DSD architecture and the required responses to the prompts.
Table 6-2 DSD Configuration Prompts when SSL Communication is Enabled
Prompt Response
Do you want to enable SSL configuration for
any of the components? (y/n)? [n]
To enable SSL configuration, enter y.
Do you want to use your local host as the
Certificate Authority? (y/n)? [y]
Enter y.
Note If you are configuring SSL along with a
DSD architecture, the Certificate
Authority must run on the local host.
Configure Info Server failover on Info
Server? (y/n)? [n]
Press Return to accept the default setting (no
failover).
Do you want to configure the Info Server
for SSL? (y/n)? [n]
Enter y to configure the Info Server for SSL
communication.
Enter the port number for the Info Server
- SSL [4400]:
Do one of the following:
• To accept the default port number (4400),
press Return.
• To specify another port number, enter the port
number.
The following message appears:
INFO: Adding entry to omni.dat for
INFOSERVER
Do you want to configure this server to be
part of a Dual Desktop Server (DSD)
architecture? (y/n)? [n]
Enter y to select DSD configuration.
The following message appears:
INFO: Configuring <SERVER_NAME> for DSD
architecture ..
Is <INFO_SERVER_NAME> the Master Info
Server in the DSD configuration? (y/n)? [y]
This prompt appears if you specify that the Info
Server is to be part of a DSD architecture.
Do one of the following:
• To accept the default setting (the Info Server
that you are configuring on this host, named
INFO_SERVER_NAME will be the Master
Info Server in the DSD architecture), press
Return.
• If the Info Server installed on the will not be
the Master Info Server in the DSD
configuration, enter n.
Do you want to create a Desktop Info Server
on the current host? (y/n)? [y]
Press Return to create a Desktop Info Server.
The following message appears:
The Info Server <INFO_SERVER_NAME> has been
configured to be part of a DSD
architecture.