Filter
Top Products
1-26
Cisco SN 5428-2 Storage Router Software Configuration Guide
OL-4691-01
Chapter 1 Before Configuring SN 5428-2 Storage Router Software
Where to Go Next
Figure 1-23 SN 5428-2 Interface Naming System
Table 1-6 shows valid interface type designators for the SN 5428-2; Figure 1-24 shows each interface
location and interface name on the SN 5428-2.
Figure 1-24 SN 5428-2 Chassis-Slot Numbering
Where to Go Next
When you are ready to configure the SN 5428-2 software, proceed to one of the following chapters in
this configuration guide according to your needs:
• Chapter 2, “First-Time Configuration”—For initial setup or after configuration has been reset to
factory default configuration
• Chapter 3, “Configuring System Parameters”—Using the CLI for setting up and modifying system
parameters
• Chapter 4, “Configuring for VLAN”—Using the CLI for setting up and modifying VLAN
configurations
• Chapter 5, “Configuring Fibre Channel Interfaces”—Using the CLI for setting up and modifying FC
interface and zoning configurations
• Chapter 6, “Configuring SCSI Routing” —Using the CLI for setting up and modifying SCSI routing
configurations
• Chapter 7, “Configuring Transparent SCSI Routing” —Using the CLI for setting up and modifying
transparent SCSI routing configurations
• Chapter 8, “Configuring FCIP” —Using the CLI for setting up and modifying FCIP configurations
• Chapter 9, “Configuring Authentication”—Using the CLI for setting up and modifying
authentication configurations
aan
Interface type Chassis slot
48421
Table 1-6 Interface Type Designators
Interface Type Description
fc Fibre Channel
ge Gigabit Ethernet
85739
ge1 ge2 fc1 fc2 fc3 fc4 fc5 fc6 fc7 fc8