Filter
Top Products
14
Installing the Cisco WAE Inline Network Adapter
OL-12480-03
Installing Adapters in the WAE-512 and WAE-612 Appliances
Caution For proper cooling and airflow, replace the cover before turning on the device. Operating the device for
extended periods (over 30 minutes) with the cover removed might damage device components.
Installing an Inline Network Adapter
Before you install adapters, review the following information:
• The adapter slots are on the riser card assembly. You must first remove the riser card assembly to
access the adapter slots. (See Figure 8.)
• The device has two Peripheral Component Interconnect-Extended (PCI-X) adapter slots:
–
PCI-X slot 1 is for one full-height three-quarter-length adapter.
–
PCI-X slot 2 is for one low-profile half-length adapter; however, it is not used in this device.
• You must install supported adapters in PCI-X slot 1. (This slot is labeled “Slot 1” on the back of the
device.)
Caution When you handle static-sensitive devices, take precautions to avoid damage from static electricity. For
details on handling these devices, see the “Protecting Against Electrostatic Discharge” section on
page 7.
Note The illustrations in this document might differ slightly from your hardware.
To install an adapter, follow these steps:
Step 1 Review the safety information in the “Safety Guidelines” section on page 5.
Step 2 Power down the device and peripheral devices.
Step 3 Disconnect the power cord and then all external cables from the device.
Step 4 Remove the device cover.
Step 5 Grasp the riser card at the rear edge and lift to remove the riser card assembly. (See Figure 8.)