Filter
Top Products
12
Catalyst 6000 Family Multilayer Switch Feature Card 2 Installation Note
78-10605-03
Installing the MSFC2
Step 4 Carefully seat the MSFC2 onto the supervisor engine (see Figure 6).
Step 5 Using your thumbs, apply pressure at the locations shown in Figure 6 to ensure that the MSFC2 is
securely seated on the supervisor engine.
Caution Ensure that the MSFC2 is securely seated before you install and tighten the cap nut and securing
screws. Using the screws to seat the MSFC2 could warp the card.
Caution Use care not to damage the connectors on the supervisor engine. If you damage a connector, you will
have to return the supervisor engine to Cisco for repair.
Figure 6 Seating the MSFC2 on the Supervisor Engine
Step 6
Use a Phillips-head screwdriver to install the screws that secure the MSFC2 to the supervisor engine.
(See Figure 7).
Caution You must install all screws. The screws provide grounding between the MSFC 2 and the supervisor
engine. Failure to install all screws will invalidate the safety approvals and can cause fire and
electrical hazards.
SUPERVISOR 2
CONSOLE
CONSOLE
PORT
,MODE
PCMCIA EJECT
SWITCH LOAD PORT 1 PORT 2
1%
100%
PW
R MGMT
SYSYEM
CO
NSO
LE
RESET
Apply pressure to
these areas
63699