Filter
Top Products
13
Catalyst 6000 Family Multilayer Switch Feature Card 2 Installation Note
78-10605-03
Installing the MSFC2
Figure 7 Installing the Screws
Step 7 Install the supervisor engine in the Catalyst 6000 family switch. (Refer to the Catalyst 6000 Family
Module Installation Guide for installation instructions.)
Caution The hardware on both supervisor engines in a single chassis must be identical. If you have redundant
supervisor engines, you must install an MSFC2 on each supervisor engine.
Step 8 If you are installing an MSFC2 on a redundant supervisor engine, go to Step 3 in the “Preparing the
Supervisor Engine” section on page 7 and follow the procedure for removing the supervisor engine.
Step 9 Power up the switch.
Step 10 Depending on the software running on the switch, do one of the following steps to verify the
installation:
• Cisco IOS for the Catalyst 6000 Family of Switches product on the supervisor engine and the
MSFC2:
Verify that the switch is online. This indicates that the system acknowledges the new module and
has brought it online.
• Catalyst supervisor engine software on the supervisor engine and Cisco IOS on the MSFC2:
Enter the show module command to verify that the system acknowledges the new module and has
brought it online.
SUPERVISOR 2
CONSOLE
CONSOLE
PORT
,MODE
PCMCIA EJECT
SWITCH LOAD PORT 1 PORT 2
1%
100%
PW
R M
GM
T
SYSYEM
CONSOLE
RESET
63700