Filter
Top Products
3-11
The relationship between the offset adjustment screw and the print head
heating element is shown below:
2 When print darkness on the left and right sides of the label is not equal:
Adjustments may be needed if paper with different width is used. Print
darkness is affected by the amount of pressure on the print head so it
must be adjusted with the head pressure adjustment screw if necessary.
The pressure on the right side of the print head, viewed from the front
panel, is adjusted by turning the head pressure adjustment screw.
Turning the screw clockwise decreases the pressure, and turning the
screw counterclockwise increases the pressure.
The condition of the right side of the print head can be checked through
the upper frame window, which is located at the front of the printer
mechanism unit.
a) Print head position for label
Offset adjustment screw
Offset verification window
b) Print head position for tag
Heating element
Heating element
Offset adjustment
screw
Offset verification window
a
b