Filter
Top Products
— 25 —
4.5 Communication by Bluetooth
For the Bluetooth communication, it is necessary to choose CMP-10BT
and set the DIP switches for Bluetooth.
As built-in Bluetooth module supports Serial Port Profile, host machine
needs to communicate with CMP-10BT based on serial port profile.
Please refer to the software manual of the host machine for the details.
When CMP-10BT connects through the Bluetooth interface, the host
machine may require a pin code. The last 4 characters of the Bluetooth
Address that prints on the printer self test are the pin code that should
be entered in to the host machine.
4.6
Reading Mag Stripe Card (Only Model with Built-in Mag Stripe Card Reader)
To read the mag stripe card, it is necessary to send a special command
to the printer.
For the command, refer to Command Reference supplied separately.
If mag stripe card command is entered, Power LED lights red.
While the Power LED continues to light for 10 seconds, swipe the card
be read during that time.
If 10 seconds has passed or reading is completed, the printer returns
to normal mode.
Slide the card with the magstriped surface down to pass the magstripe
over the reader part.
When reading has completed, buzzer sounds momentarily and Power
LED changes to green.