Filter
Top Products
Chapter 4 Media (Paper) and Ribbon
− 25 −
4. Insert the bobbins into the source ribbon and destination paper cores respectively.
5. Fit the destination paper core with the bobbin on the left side ribbon shaft holder and click into position.
6. Feed the ribbon bobbin a certain length and set it on the right side ribbon shaft holder and click into
position.
7. Pass the ribbon through the lower side of the printhead block onto the destination ribbon core. At this
time, the end of the ribbon is stuck to the destination ribbon core using the adhesive leader supplied
with our genuine consumables. Alternatively, clear adhesive tape may be used. Remove any slack in
the ribbon by winding the destination ribbon core clockwise.
8. Turn the blue printhead lever counterclockwise to lock the printhead block.
Adhesive leader (or clear adhesive tape)