Filter
Top Products
2-1
Chapter 2
Installation
Introduction to EthIR LAN Components
Clarinet EthIR LAN includes EthIR Switch and EthIR Beam. Model number
description follows. For description of “Pass Through” mode refer to page 2-6:
ES208 - 8 port Pass Through
ES216 - 16 port Pass Through
ES608 - 4 port EthIR LAN with 4 PDA sockets
ES101 - single port infrared only
ES301 - single infrared port with additional Ethernet port and OBEX function
ES3011b - single infrared port with 802.11b uplink and OBEX function
ES1000 - single infrared port with flash memory for content and OBEX
function
After EthIR LAN is installed you must configure it for your network. See Chapter 3,
“Configuring EthIR LAN” for additional information on this topic.
Installation Requirements
Wiring
The EthIR Switch (ES208 / 216 / 608) requires standard UTP Category 3 or 5 wire
with 4-pair wiring to the EthIR Beam. The EthIR Switch (ES101/301/3011b/1000)
single port uses a mini-DIN connector cable. The EthIR Switch uplink supports both
100Base-T, 10Base-T Ethernet and 802.11b RF. Please note: 100Base-T4 is not
supported.
Power (ES 208 / 216 / 608)
The EthIR Switch automatically detects and supports both the US and European
110/220 power supply and configures itself accordingly.
Power (ES101 / 301 / 3011b / 1000)
The ES101 will have a power supply specific to the installed region.
Resetting
To reset the system, unplug the EthIR Switch power cord and wait at least 4 seconds
before plugging the unit in again.