Filter
Top Products
OWNER’S MANUAL
9. INSTALLATION INSTRUCTIONS
The OHM720/OHM820 is an overhead, flip-down 7"/8” monitor with an
infrared (IR) eye. It will accept a video signal from any video source with
composite video out. The IR eye will work directly with any Clarion video
source product with an IR Eye Input.
1. Look over the vehicle for a location for the monitor. Each vehicle is
different and locations will vary. Make sure the monitor will not interfere
with the driver.
2. Run necessary wires to the mounting location. When necessary cut the
headliner and pull wires through.
3. Use a 12"W x 12"L x ½" or ¾" thick piece of plywood to mount the
OHM720/OHM820.
4. Silicone the piece of plywood to the top of the roof or screw the plywood to
the dome light mounting assembly and or the roof support rail.
5. Once the plywood has been mounted, connect the IR, power and DIN
cables to the designated sources.
6. Make sure all wires and DIN cables are way from screws when drilling.
7. Screw the monitor and universial pod assembly (factory pre-assembled)
into the plywood using 4 wood screws (not supplied). Use the shortest
screws possible to prevent roof penetration.
6
720 820 manual.qxd 12/4/01 10:17 AM Page 7