ClearOne comm Scan Converter Power Supply User Manual


 
Appendix
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
15
Appendix
14
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
Warning: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
NOTE:This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules.These limits are
designed to provide reasonable protection against harmful interference in a residen-
tial installation.This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the inter-
ference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
– Consult the dealer or an experienced radio or TV technician for help.
Supplied cables must be used with this unit to ensure compliance with the Class B
FCC Limits.
Also a Class B digital device meets all requirements of the Canadian Interference-
Causing Equipment Regulations.
Compliance
Declaration of Conformity
In accordance with ISO/IEC Guide and EN 45014:
Manufacturer’s Name ClearOne Communications, Inc.
Manufacturer’s Address 1825 Research Way
Salt Lake City, UT 84119
Declares that Product Scan Converter
Conforms to the following product specifications
– Safety International: IEC 950:1991
– Europe: EN 60950: 1992
This product complies with the requirements of the Low Voltage Directive
72/23/EEC.
EMC CISPR22: 1985/EN55022: 1995 Class B
EN 55022 Class B: 1998
EN 61000-3-2 1995
EN 61000-3-3 1995
EN 55024 1998
CFR 47 1999 §15.107 and §15.109 Class B
This product complies with the requirements of the EMC Directive 89/336/EEC.
According to CFR 47:1999, Sections 15.107 and 15.109 – Class B
This device complies with Part 15 of the FCC rules. Operation is subject to the fol-
lowing two conditions: (1) This device may not cause harmful interference, and (2)
This device must accept any interference received, including interference that may
cause undesired operation.