Filter
Top Products
Chapter 3: Setting up the Printer12
A798 Thermal Receipt Printer: User Guide A798-UG00001 Rev. A 10/07 10/07 A798-UG00001 Rev. A A798 Thermal Receipt Printer: User Guide
A798 Thermal Receipt Printer: User Guide A798-UG00001 Rev. A 10/07 10/07 A798-UG00001 Rev. A A798 Thermal Receipt Printer: User Guide
Load or change the receipt paper
Caution: You must use qualified paper rolls with TPG printers. The list of qualified paper is in Chapter 5. Using
unqualified paper may void the warranty.
You will later use the same procedure to change the receipt paper as you will to load it during installation. The minor
difference is noted in the directions below.
If you are installing the printer using the wall mount kit, you may find it easier to load the paper roll after installation.
1 Open the receipt cover by pushing up evenly on each side of the cover until it unsnaps (1).
2 Loading: Remove the test printout (2) and starter roll. Slide the supports off the roll (3).
Changing: Remove the used paper roll.
3 Tear a clean edge on the new receipt paper roll, making sure the tape has been completely removed.
4 Place the receipt paper into the paper compartment so it unrolls from the bottom (4). Leave a few inches of paper
sticking out of the printer.
5 While holding the paper in place, close the receipt cover (5). To test that the paper is loaded correctly, advance the
paper with the paper feed button.
Note: If the paper jams, make sure the roll is inserted correctly. Check the illustration above for proper orientation.
6 Tear the excess paper off against the blade in the cover (6).
1
6
4