Filter
Top Products
Index 5
connecting the Network
Transient Protector 2-5
connecting the Network
Transient Protector,
illustrated 2-5
connecting to utility
power 2-7
installing an external battery
module 2-3
installing an external battery
module, illustrated 2-4
requirements 2-2
hardware 2-2
software 2-2
tools 2-2
silencing the audio alarm 2-10
starting the UPS
checking the Battery Recharge
Date label 2-6
checking the battery recharge
date, illustrated 2-6
for the first time 2-6
warning concerning
grounding 2-7
warning concerning red
LEDs 2-10
J
Japanese Notice A-5
L
LanSafe III
overview 1-7
requirement for cabling to host
computer 2-4
LED 01 See AC Input LEDs
LED 02 See AC Input LEDs
LED 03 See AC Input LEDs
LED 04 See AC Input LEDs
LED 05 See Site Wiring Fault
LED
LED 06 See Battery Charge LEDs
LED 07 See Battery Charge LEDs
LED 08 See Battery Charge LEDs
LED 09 See Battery Charge LEDs
LED 10 See Battery Service LED
LED 11 See Load Level LEDs
LED 12 See Load Level LEDs
LED 13 See Load Level LEDs
LED 14 See Load Level LEDs
LED 15 See Communication LED
LED 16 See ON LED
LED display See front panel,
indicators
Load Level LEDs
explained 3-7
troubleshooting alarm
condition 6-4
Low Battery
configuraton parameters
explained 4-4
specifying audio alarm 4-4
M
maintenance, battery 5-9
matching, utility voltage with UPS
configuration 4-7
modes of operation See Standby
mode, Operate mode, Configure
mode, Sleep mode
modifications to equipment See
Federal Communications
Commission (FCC) notice
N
Network Transient Protector
connecting 2-5
connecting, illustrated 2-5
features 1-10
not connecting to a digital
PBX 2-5
overview 1-10
nominal utility voltage level