Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
5-16 Removal and Replacement Procedures
5.3.4 Pointing Devices
There are two pointing devices available for the computer: a modular touchpad and a
modular trackball. Both devices are removed and installed the same way.
To remove the pointing device, complete the following steps:
1. Disconnect the AC power (section 5.3.1).
2. Undock the computer from its auxiliary base, if necessary (See Section 5.3.2).
3. Remove the handle battery pack (Section 5.3.3).
4. Remove the DualBay device (Section 5.3.4).
5. To release the pointing device, push in the metal retaining clip
1
located in the wall
between the DualBay and the pointing device bay.
6. While holding in the retaining clip, pull the pointing device straight out of the
computer base
2
.
Figure 5-14
. Removing the Pointing Device (Touchpad)